Por: Victor J.

Victor J. — Tue, 30 Nov -0001 00:00:00 +0000

100

Por: PHX Ray

PHX Ray — Tue, 30 Nov -0001 00:00:00 +0000

Even My Wife Loves This Thing!!!
Tore out 20,000 lb (3000sqft) of Saltillo tile without a hiccup over six days. Re-sharpened the bits a few times. Could have done the entire job with two bits (the 2″ tile bits). Incredible machine. (Keep bits cool between grindings by dipping in cool water!!! Otherwise you’ll kill the temper on the bit and they will dull quickly!!!)Then I had to re-shape three hideous Kiva fireplaces after saw cutting. With a point bit and the small 1″ chisel, the job was a snap.Then, I had to replace four vent covers off my foam roof with larger ones. The 6″ grout chisel slid along the galvanized without harming it and peeled back the foam with ease.Then, I had to tear out the tile shower in the master bath. With the 1″ chisel blade, it cracked the wall tile and the point chisel easily cracked the floor pan, popping it clear of the slab. Hard work made much easier with this machine.Then, I had to chisel out between saw cuts in the living room floor receptacle and in the shower floor where I had to re-locate a drain. Cake. Took a few minutes.THEN, my wife, who was dutifully pulling up carpet nail strips with a hammer and chisel, saw how easy the Bosch did the job, now SHE is using it to get all the nail strips up. Initially leery of a $700 tool, she has said more than once how absolutely indispensable this thing has been on this remodel job. We even used it to pull off baseboards!This Bosch is a very precise “destroyer.” it brings a tremendous amount of energy to a small area and allows you to control that energy to your advantage. After paying for itself many times over, we’ll still hold on to it after we are through because it makes digging holes for plants much easier here in rocky Phoenix! I even have more patio tile to remove at some future date. Awesome tool indeed. Indispensable!One note: TAKE CARE OF YOUR BITS!!! You have to put a tiny amount of the supplied grease on the bit shanks to keep the bits from wearing the hammer chuck. Clean them every time you remove one and only use a pea-sized amount on the next bit you use. That will keep the chuck in great shape and keep the bits running smooth and cool.I’d give this thing ten stars if I could.

Comentarios en: BOSCH 11316EVS Martillo de Demolición SDS-Max, 14.0 Amps, 120V, 18.4 ft-lbs, 900-1890 RPM, Vario-Lock, Azul Bosch

Por: Victor J.

Por: PHX Ray